Use this info for putting up crown molding or making picture frames.

The Table following these instructions is used when your walls are not square.

·  Compound Method (Flat)  Compound Miter Saw

·  Molding laying with broad back surface down flat on saw table.

·  You must flip the material around to cut both ends of the inside and outside corners.


Molding sitting in a miter and bevel saw

INSIDE CORNER

OUTSIDE CORNER

Left Side:

1.       Top of Molding Against Fence

2.       Bevel Set at 33.85º

3.       Miter Right at 31.62º

4.       Save Left End of Cut

Right Side:

1.       Bottom of Molding Against Fence

2.       Bevel Set at 33.85º

3.       Miter Left at 31.62º

4.       Save Left End of Cut

Left Side:

1.       Bottom of Molding Against Fence

2.       Bevel Set at 33.85º

3.       Miter Left at 31.62º

4.       Save Right End of Cut

Right Side:

1.       Top of Molding Against Fence

2.       Bevel Set at 33.85º

3.       Miter Right at 31.62º

4.       Save Right End of Cut

 

* Top of molding doesn’t have decorative edge

* Bottom of molding has decorative edge