Use this info for putting up crown molding or making picture frames.

The Table following these instructions is used when your walls are not square.

Compound Method (Flat) Using DW703/DW715 Compound Miter Saw
  1. Molding laying with broad back surface down flat on saw table.
  2. You must flip the material around to cut both ends of the inside and outside corners.

Molding sitting in a miter and bevel saw

INSIDE CORNER OUTSIDE CORNER
Left Side:
  1. Top of Molding Against Fence
  2. Bevel Set at 33.85º
  3. Miter Right at 31.62º
  4. Save Left End of Cut

Right Side:

  1. Bottom of Molding Against Fence
  2. Bevel Set at 33.85º
  3. Miter Left at 31.62º
  4. Save Left End of Cut
 Left Side:
  1. Bottom of Molding Against Fence
  2. Bevel Set at 33.85º
  3. Miter Left at 31.62º
  4. Save Right End of Cut

Right Side:

  1. Top of Molding Against Fence
  2. Bevel Set at 33.85º
  3. Miter Right at 31.62º
  4. Save Right End of Cut

 
* Top of molding doesn’t have decorative edge
* Bottom of molding has decorative edge